Regulation 55

the strata certified plan number must be endorsed on the bottom right‑hand corner of the plan as “ST ........”;

the Mukim or Town Subdivision of the land parcel must be stated on the immediate left‑hand side of the strata certified plan number;

the plan must measure 500 millimetres in length by 353 millimetres in width and must have clear margins on the face of each sheet of not less than 40 millimetres on the left‑hand side and not less than 15 millimetres on the right‑hand side, at the top and at the bottom;

each sheet must be numbered consecutively and the number must be endorsed on the top right‑hand corner of each sheet as “Sheet ......”;

the first sheet must contain the strata title plan heading, a site plan, the relevant field book numbers and pages, the relevant cadastral map numbers and the certifications mentioned in rule 56;

the second sheet must contain a plan schedule of subdivision, a legend of the common property, an elevation sketch, and where applicable, a legend setting out the provisional lots and a table of accessory lots;

subsequent sheets must contain storey plans; (h)where a strata lot occupies more than one storey, subsequent sheets must contain a table showing —

the strata area of each storey of the strata lot;

the total strata area of the strata lot;

the void area (other than an existing void area) in each storey of the strata lot, if any; and

where there are existing void areas in the strata lot —

the floor area of each storey of the strata lot;

the total floor area of the strata lot;

the existing void area in each storey of the strata lot; and

the total existing void area in the strata lot.